Operating The Answering Machine - Sharp UX-460 Operation Manual

Operating the Answering Machine

Activating the answering machine
Activate the answering machine before you go out as follows:
Press the RECEPTION MODE key
until the arrow in the display points to
TAD.
The outgoing message will play
(you can stop playback by pressing
the STOP key).
It will not be possible to set the
reception mode to TAD if a general
outgoing message has not been
recorded.
When the reception mode is set to TAD, the UX-460 will answer
incoming calls after two rings if it has received at least one incoming
message, or after four rings if no messages have been received. (For
more information, see Toll Saver in Remote Operations in this
chapter.)
Note: If the memory is full from messages previously recorded, MEMORY
IS FULL will appear in the display. To set the reception mode to TAD, you
must first erase some or all of the stored messages.
Note: In TAD mode, the machine will automatically switch to fax
reception if it detects a period of silence longer than six seconds after
answering a call. For this reason, if a caller pauses for this length of time
while leaving a message, they will be cut off.
Operating the Answering Machine
RECEPTION
MODE
FAX
TEL
TAD
37