Sharp UX-460 Operation Manual page 137

LINE IS IN USE
MEMORY IS FULL
MEMORY PRINTING
NO DATA
NO # STORED
OUT OF PAPER
ON HOOK DIAL
OVER HEAT
PAPER JAMMED
READY TO SEND
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been
received to memory because printing is not possible
(an additional message will indicate the problem),
resolve the problem so that printing can continue
(see Substitue Reception to Memory in Chapter 3). If
you are attempting to transmit from memory, see
Sending Documents from Memory in Chapter 7.
The fax is preparing to or printing out a document
from memory.
This appears if you attempt to search for an
automatic dialing number when none have been
stored.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
You are out of printing paper (or the paper release
plate is open). Load paper as described in Loading
Printing Paper in Chapter 1.
The SPEAKER key has been pressed and the fax is
waiting for you to dial. (To return to the date and time
display, press the SPEAKER key again.)
The print head has overheated. Operation can be
continued once it cools.
The printing paper is jammed. See the following
section, Clearing Paper Jams .
A document has been loaded and the fax is waiting
for transmission or copying instructions.
Display Messages
135