Sharp AR-651 Operation Manual page 27

6
Once the final original has been scanned, press the FINISHED key.
- When the reversing automatic document feeder is used, and the single-feed mode is selected, the
procedure is slightly different from the above. Procedure of using the single-feed mode
- After starting copying, press the JOB STATUS key on the control panel, then press the
STATUS key on the touch panel to indicate which drawer is in use. When paper runs
out of each drawer, the empty drawer will flash.
Exiting Copy Papers
The paper exits with its printed side down except in the following
cases.
When paper is exited with its printed side up:
- When 'Non-sort / Non-staple' mode is selected for setting
the original on the original glass.
- When the paper size is not set for bypass copying.
When Coming Across the Situations below
To make multiple sets of copies:
- Key in the copy quantity.
- To correct the input copy quantity, press the
When the paper has run out in the middle of copying:
JOB STATUS key flashes. Press this key to check which drawer
is flashing and add papers.
To stop a copy operation
When this message appears "Wait ":
The copier may automatically go into the adjustment mode. It
will soon start working. Do not turn OFF the power. Just wait
for a while.
CLEAR key.
Page 2-15
1
Page 5-3
2
3
4
5
6
7
8
9
10
11
12
2-3