Connecting A K-Series Ac Power Supply To Ac Power; Removing A Cover Plate From The K-Poe-4Bay Poe Shelf - Enterasys K-Series Installation Manual

Figure 3-4
1 Power supply slot
2 Coverplate

Connecting a K-Series AC Power Supply to AC Power

To power up the K-Series AC power supplies installed in the K-POE-4BAY PoE shelf:
1. Plug one end of each power cord (supplied with the power supply) into the AC power socket
on the front panel of the power supplies.
2. Plug each of the power cords into separate dedicated 15 A/120 Vac receptacles.
3. Ensure that the LEDs on each power supply are green.
If you experience any problems with this installation, contact Enterasys Networks for assistance.

Removing a Cover Plate from the K-POE-4BAY PoE Shelf

Note: If multiple power supplies are installed, repeat the following procedure for each supply.
For redundancy using multiple K-Series AC power supplies, each of the power cords from the
power supplies must be connected to dedicated 15 A AC power circuits.
Connecting a K-Series AC Power Supply to AC Power
3 Coverplate screws
Enterasys K-Series K-POE-4BAY PoE Shelf Hardware Installation Guide 3-5