Setting The Take-Over Position On The Loading Station - Pfaff 3307-1 Instruction Manual

13

Setting the take-over position on the loading station

.40
Requirement
1. When at the same height, the bearing surface of the loading station should be parallel
to the button bearing surface of the button holder, whereby the button holder should
position in the centre of the cutout of the loading station.
2. When the button is touching hook 8, the pins of the button holder should lock into in
the button, without moving its height or side position.
3
Fig. 13 - 38
● With parameter "616" (value "6") move the button holder to the loading station.
● Slightly loosen screws 1.
● Adjust screw 2 (nut 3) and screws 4 (nuts 5) in accordance with requirement 1.
● Tighten screws 1.
● Adjust screw 6 (nut 7) in accordance with requirement 2.
2
1
108-134
Following this adjustment, without switching off the machine or
disconnecting it from the pneumatic system, the adjustment as described in
Chapter 13.39 Adjusting the loading cylinder must be carried out with the
same parameters.
4
5
4
Adjustment
8
6
7
99