Table of Contents
Advertisement
Adjustment
13
Adjusting the loading cylinder
.39
● Adjust loading cylinder 1 (nut 2) in accordance with requirement 1.
● Lower the loading cylinder 1 using parameter "616" (value "4").
● Turn nut 3 (nut 4) in accordance with requirement 2.
98
Requirement
1. The bottom edge of the case of loading cylinder 1 should be positioned 6 mm below
the bracket.
2. When the loading cylinder 1 is lowered, the upper edge of the button holder 5 should
be positioned 0.5 mm below the button clamp.
2
5
108-080
Fig. 13 - 37
Following this adjustment, without switching off the machine or
disconnecting it from the pneumatic system, the adjustment as described in
Chapter 13.38 Setting the discharge position on the button clamp must be
carried out with the same parameters.
1
4
108-079
3
5
Advertisement
Table of Contents
