Putting The Receiver Into Operation; Preparing The Receiver For Use - Sennheiser evolution wireless series EM 100 Instruction Manual

Putting the receiver into operation

Preparing the receiver for use

If you want to mount the receiver
If you want to set up the receiver
Setting up the receiver on a flat surface
CAUTION! Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into contact with
other synthetics. Despite a thorough testing of the synthetics used by us,
we cannot rule out the possibility of staining.
Fastening the
stacking elements
Recommendations for optimum reception
To ensure optimum reception even under difficult conditions, we
recommend connecting remote antennas and, if necessary, using
antenna splitters (see "Accessories and spare parts" on page 49).
When rack-mounting the receiver, you can mount the supplied
antennas to the front of the rack by using an antenna front mount
kit. When mounting more than one receiver into a rack, you should
use remote antennas.
Read the corresponding chapter on page 13.
Read the next chapter.
Do not place the receiver on delicate surfaces.
The stacking elements are designed to help protect the operating
elements from damage or deformation, e.g. if the receiver is
dropped. Therefore, fasten the stacking elements, even if you do
not want to stack your receivers.
Putting the receiver into operation
into a 19" rack:
on a flat surface:
11