Putting The Receiver Into Operation - Sennheiser evolution D1 User Manual

Putting the products into operation
16

Putting the receiver into operation

Fitting the device feet
ATTENTION
Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with varnish, polish or synthetics
which might cause stains when they come into contact with other synthetics.
Despite a thorough testing of the synthetics used by us, we cannot rule out
the possibility of staining.
Do not place the receiver on delicate surfaces.
Do not fit the device feet when mounting the receiver into a rack.
Clean the recesses for the device feet at base of the receiver.
Fit the device feet to the recesses of the receiver.
Place the receiver on a flat, horizontal surface.
The device feet will adhere reliably to the receiver only after some time.
Avoid moving the receiver during this time.
Mounting the rack mount "ears"
The rack mount "ears" are designed to help protect the operating ele-
ments from damage or deformation, e.g. if the receiver is dropped.
Therefore, always fasten the rack mount "ears", even if you do not
want to rack mount the receiver.
To fasten the rack mount "ears":
Unscrew and remove the two recessed head screws on each side of the
receiver.
Secure the rack mount "ears"
viously removed recessed head screws.
Connecting the rod antennas to the receiver
The supplied 2G4 rod antennas can be mounted quickly and easily. The rod
antennas are suitable for all applications where – good reception conditions
provided – a wireless transmission system is to be used without a large
amount of installation work
1
1
to the sides of the receiver using the pre-