Cleaning The Set 830 S-Mke; Cleaning The Transmitter And The Receiver; If A Problem Occurs - Sennheiser Set 830 S-MKE Instruction Manual

Cleaning the Set 830 S-MKE

Cleaning the Set 830 S-MKE

Cleaning the transmitter and the receiver

CAUTION!
Before cleaning, disconnect the transmitter from the
mains.
Use only a slightly damp cloth to clean the devices.

If a problem occurs ...

The transmitter does not switch on
Possible cause
Is the mains unit
connected correctly?
Is the sound source
switched on?
Is the volume of
the sound source
sufficient?
Is the transmitter
set to operating
mode 2 (see
page 29)?
24
Liquids can damage the electronics of the
devices!
Liquids entering the housing of the devices
can cause a short-circuit and damage the
electronics.
Keep all liquids far away from the devices.
Do not use any cleansing agents or
solvents.
Solution
Check the connection of the mains
unit to the transmitter and to the
mains (see page 10).
Switch your sound source on.
Set the volume on your sound
source to a medium level.
Take the receiver out of the
charging compartment. The trans-
mitter automatically switches on.