Sennheiser 500 Series Instruction Manual page 29

Display
Easy Setup
Frequency Preset
Name
AF Out
Equalizer
Auto Lock
Advanced
Exit
"Easy Setup"
Reset List
Current List
Scan New List
Exit
Extended menu "Advanced Menu"
Tune
Sync Settings
Guitar Tuner
Pilot Tone
Warnings
LCD Contrast
Reset
IP-Address
Software Revision
Exit
Submenu "Sync Settings"
SKM Settings
SK Settings
Exit
"SK Settings"/"SKM Settings"
Here you can activate/deactivate the transfer of the following transmitter parameters: Sensitivity, Auto Lock, Mute
Mode (SK), RF Power and Cable Emulation (SK) (see page 28)
"Warnings"
AF-Peak
Low RF-Signal
RF-Mute
Function of the menu item
Scans for unused frequency presets, releases and selects frequency presets
Changes the frequency bank and the channel
Enters a freely selectable name
Adjusts the audio output level
Adjustment range: –24 dB to +24 dB, adjustable in 3-dB steps, 6 dB gain reserve
Special function "gain reserve":
When you have adjusted a level of +18 dB, turn the jog dial
in this position until the next higher value appears.
Changes the frequency response of the output signal
Activates/deactivates the automatic lock mode
Calls up the extended menu
Exits the operating menu and returns to the current standard display
Releases all locked frequency presets and selects an unused frequency preset
Selects an unused frequency preset
Scans for unused receiving frequencies (frequency preset scan)
Exits the submenu "Easy Setup" and returns to the main menu
Sets the receiving frequencies for the frequency banks "U1" to "U6"
Special function: Sets a channel and a receiving frequency for the frequency banks "U1" to
"U6":
Select this menu item and call it up by pressing the jog dial
selection appears.
Activates/deactivates the parameters to be transferred to the transmitters
Selects the mode of the guitar tuner function
Activates/deactivates the pilot tone evaluation
Activates/deactivates the warning messages
Adjusts the contrast of the display panel
Resets the receiver
Adjusts the IP address of the receiver
Displays the current software revision
Exits the extended menu "Advanced
Activates/deactivates the parameters to be transferred to the SKM radio microphones
Activates/deactivates the parameters to be transferred to the SK bodypack transmitters
Exits the submenu "Sync Settings" and returns to the extended menu
Activates/deactivates warnings (color change and warning messages):
Audio overmodulation
RF signal is weak
RF signal is too weak or no RF signal
"Advanced Menu"
Menu" and returns to the main menu
Overview of the operating menus
²
to the right and keep it
²
until the channel
"Advanced Menu"
27