Symbols; Safety Requirements - Stiga BL 2.6 E Operator's Manual

IDENTIFICATION OF THE COMPONENTS / SYMBOLS / SAFETY WARNINGS
Maximum noise and vibration levels [1]
Sound pressure level
– Measurement uncertainty
Measured acoustic power level
– Measurement uncertainty
Guaranteed acustic power level
Vibration level
– Measurement uncertainty
[1] Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric
equipment as well as temporary estimates of the load through the vibrations.
WARNING! The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated.
Try to limit as much as possible the amount of vibration. To reduce the amount of vibration it is recommended, for example, to wear gloves
during use of the machine and to limit the hours of operation. In this regard, all the operational cycle phases must be taken into consideration
(such as when the power tool is switched off or when it is switched on, but it operates without load).
TECHNICAL DATA
Power supply voltage
Power supply frequency
Power
Motor speed
Protection class
Mass

2. SYMBOLS

1 2
1) Warning! Danger. The failure to use this ma-
chine correctly can be hazardous for oneself
and others. Read the instruction manual before
using the ma chine.
2) Danger of dismemberment! Never use the ma-
chine with the grille open.
3) Keep all persons away from the work area
whilst mowing.
3. SAFETY WARNINGS
HOW TO READ THE MANUAL
Certain paragraphs in the manual contain particularly
significant information and are marked with va rious
levels of highlighting with the following meaning:
NOTE
or
IMPORTANT
3
These give details or further
4 5
6
4) Do not leave the machine in the rain (or in
damp conditions).
5) Disconnect the plug from the mains before
commencing maintenance work or if the power
cord is damaged.
6) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safetyglas-
ses and hearing protection.
information on what has already been said, with the
aim of preventing damage to the machine.
WARNING!
in the risk of injury to oneself or others.
DANGER!
in the risk of serious injury or death to oneself or
others.
BL 2.6 E
dB(A) 75
dB(A) 3
dB(A) 95
dB(A) 3
dB(A) 98
m/s 1.7
2
m/s 1.5
2
V~ 230
Hz 50
W 2600
min 15000 - 18000
-1
= II
kg 4.7
IMPORTANT Any damaged or
illegible decals must be replaced.
Order replacement decals from
an authorised assistance centre.
Non-observance will result
Non-observance will result
3
EN