Cleaning And Inspection; Cleaning; Inspection - Omron SYSMAC 3G8F7-CLK13-E Operation Manual

Cleaning and Inspection

Controller Link Support Software
1,2,3...
Message Service
Reading an Error Log
Clearing an Error Log
9-4

Cleaning and Inspection

9-4-1

Cleaning

!Caution Do not use volatile solvents such as benzine or paint thinner, or chemical
9-4-2

Inspection

Tools and Equipment Need for Inspection
154
Read or clear the error log using the following procedure.
1. Display the Main Menu.
2. Select "E: Error log."
3. Select "R: Read."
4. Designated the node. The error log for the designated node will be dis-
played.
5. Press the F7 (Clear) Key. The designated node error log will be cleared.
Send the ERROR LOG READ FINS command (command code 2102) to the
appropriate node. Refer to 6-3-14 ERROR LOG READ.
Send the ERROR LOG CLEAR FINS command (command code 2103) to the
appropriate node. Refer to 6-3-15 ERROR LOG CLEAR.
Conduct the following periodic cleaning to keep the Controller Link Support
Board in optimum condition.
• Wipe the Unit with a dry, soft cloth daily.
• If glue, vinyl, or tape is left on the Board for long periods of time, it will
stain. Remove these items during cleaning.
cloths for cleaning. They will damage the quality of the coating on the Board.
Controller Link Support Boards must be inspected on a regular basis to
ensure correct operation. Inspections should be conducted once every 6 to 12
months. If the Board is subject to extremes in temperature or humidity,
inspections should be conducted on a more regular basis.
The following tools and equipment will be needed to perform inspection and
adjustments.
• Assorted flat-blade and Phillips screwdrivers
• Circuit tester or digital voltmeter
• Industrial-grade alcohol and clean cotton cloth
• Synchroscope
• Pen-chart recording oscilloscope
• Thermometer, hygrometer
• Optical tester
Section 9-4