Kenmore OVERLOCK 3/4D 385.16631 Owner's Manual page 22

SECTION 2. PREPARE YOUR MACHINE FORSEWgNG
Left needle tnreaa
tension dial
\N ;
Thread take-uu _
ever thread
guide
9®
(_ Insert the thread between tension discs from
the right. Then pull both sides of thread.
(_) Turn the hand wheel toward you to bring
needle bar to its highest position, then pass the
thread through thread take-up lever thread
gu ide.
Needle thread ...
guide
Needle bar
thread guic
\
b®db
® Pass the thread through needle thread guide
sliding the thread from right to left.
Pass through needle bar thread guide from left
to right.
(_ Thread the left needle from the front to tne
back and pull the thread about 10 cm (4")
from the eye of the needle to the back under
the foot.
NOTE: Needle may be easier to thread if you
remove presser foot (See page 27) and
lower the knife (See page 29).
Gently pull all four thread enes towards back of
machine.
Replace presser foot (See page 27).
Run threads under presser foot.
-- Return knife to uu position (See page 29).
Close side and looper covers.
Turf hand wheel toward you to chain off three
or four stitches.
17