Kenmore 385.128418 Owner's Manual page 46

= Clean the Shuttle Race
ThJs area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area
about every three months.
Center pm et
the shuttle
ever
case
To Clean the Shuttle Area:
1. Raise the needle bar to its highest
point and remove the bobbin case.
2. Push shuttle race levers aside. Lift
shuttle race cover and take shuttle out.
3. Clean the shuttle race with a lint
brush,
4, Put a drop of oil on the center pin of
the shuttle and shuttle race. Do not
over-oil.
Shuttle driver
Lever
Lever
Shuttle
Shuttle Race
Shuttle Race
Cover
To Replace Shuttel Assembly:
I, Position shuttle race as illustrated so that shuttle
driver is forming half moon on the left side of the
machme.
2, Hold shuttle by center p=n and position shuttle so as
to form a half moon on the right side° Pointed hook
wifl be on the bottom.
3. Place shuttle race cover rote place over shuttle
assembly.
4. Snapthe levers back into the ongmat position.
44