Kenmore 385.128418 Owner's Manual page 17

Pick Up Your Bobbin Thread
®
5. Draw thread down and into
thread guide,
6. Pul! the thread to the left and slip
it through the thread guide,
7. Thread then is slipped into needle
bar thread guide.
8, Thread needle from front to back,
NOTE:
You may want to cut the
end of the thread with sharp
smssors for eas_er needle
threading,
Raise presser foot lever. Hold
needle thread loosely in left hand
and rotate handwheel toward you
one complete turn,
24
Bring bobbin thread up by pulling
top thread.
tf you cannot pick up bobbin thread by following steps gwen above, then check:
1, Is needle threaded from front to back?
2. Is thread tangled around needle?
3, Are 3 to 4 inches of thread coming from the shuttle?
4, Is thread from shuttle tangled?
5. Is bobbin properly installed in the bobbin case?
6. Is the machine threaded according to the Instructions?
3, Pull both threads under and to the
back of the presser foot, leaving 3
to 4 inches of thread clear,
15