Lcd Description - Eaton 9SX Series Installation And User Manual

4. Interfaces and Communication
4.2

LCD description

After 5 minutes of inactivity, the LCD displays the screen saver.
The LCD backlight automatically dims after 10 minutes of inactivity. Press any button to restore the screen.
Load/equipment status
The following table describes the status information provided by the UPS.
Note: If other indicator appears, see troubleshooting on page 50 for additional information.
Operation status
Standby mode
Online mode
Battery mode
1 beep every 10 seconds
End of backup time
1 beep every 3 seconds
High Efficiency mode
Bypass mode
Page 30
Operation status
Efficiency and load group information
Cause
The UPS is Off, waiting form start-up
command from user.
The UPS is operating normally.
A utility failure has occurred and the
UPS is on Battery mode.
The UPS is on Battery mode and the
battery is running low.
The UPS is operating on High
Efficiency mode.
An overload or a fault has occurred,
or a command has been received,
and the UPS is on Bypass mode.
Battery status
Description
Equipment is not powered until
button is pressed.
The UPS is powering and protecting
the equipment.
The UPS is powering the equipment
with the battery power.
Prepare your equipment
shutdown.
This warning is approximate, and
the actual time to shutdown may
vary significantly.
The UPS is powering and protecting
the equipment.
Equipment is powered but not
protected by the UPS.
614-20306-00 - 9SX 0-6 KVA EMEA_EN
for