Ebm Tower 0-3Kva - Eaton 9SX Series Installation And User Manual

C - UPS connection
Check that the indications on the name plate located on the back of the UPS meets to the AC-power source
and the true electrical consumption of the total load.
Note: The UPS charges the battery as soon as it is connected to the AC-power source, even if
pressed.
Once the UPS is connected to the AC-power source, 24 hours of charging are required before the battery can
supply the rated backup time.
3.3

EBM Tower 0-3KVA

A - Checking the accessory EBM
9SX EBM
1
Battery power cable, attached with battery detection cable
2
Quick start
3
EBM Installation manual.
4
Discard the EBM user's guide if you are installing the EBM with a new UPS at the same time.
Use the UPS user's guide to install both the UPS and the EBM.
If you ordered other UPS accessories, refer to specifi c user manuals to check the packing contents.
614-20306-00 - 9SX 0-6 KVA EMEA_EN
1. 9SX700I / 1000I / 1500I / 2000I: connect the UPS input socket
to the AC-power source using the cable of the protected
1
equipment.
9SX3000I: connect the supplied cable
socket , then to the AC-power source.
1
2. Connect the loads to the UPS using the cables
It is preferable to connect the priority loads to the outlets
marked and the non-priority loads to the outlets marked
5
that can be programmed (see 2.2 "Rear panels").
6 7
Connect any high-power devices to the 16 A outlet.
To program shutdown of outlets
battery power and thus optimise the available backup time,
please check the in/out settings.
3. Installation
(250 V - 16 A) to the
15
.
16
during operation on
6 7
button is not
Page 15