Lcd Description - Eaton 9SX 6000VA Installation And User Manual

2. Presentation
2.5

LCD description

After 5 minutes of inactivity, the LCD displays the screen saver.
The LCD backlight automatically dims after 10 minutes of inactivity. Press any button to restore the screen.
Load/equipment status
The following table describes the status information provided by the UPS
Note: If other indicator appears, see troubleshooting on page 37 for additional information.
Operation status
Standby mode
Online mode
Battery mode
1 beep every 10 seconds
End of backup time
1 beep every 3 seconds
High Efficiency mode
Bypass mode
Page 12
Operation status
Online mode
50%
2.7kW
3.0kVA
Efficiency: 95%
Efficiency and load group information
Cause
The UPS is Off.
The UPS is operating normally.
A utility failure has occured and
the UPS is on Battery mode.
The UPS is on Battery mode and
the battery is running low.
The UPS is operating on High
Efficiency mode.
An overload or a fault has occurred,
or a command has been received,
and the UPS is in Bypass mode.
100%
30min Battery status
1EBM
Description
Equipment is powered but not
protected by the UPS.
The UPS is powering and protecting
the equipment.
The UPS is powering the equipment
with the battery power.
Prepare your equipment for
shutdown.
This warning is approximate, and
the actual time to shutdown may
vary significantly.
Depending on the UPS load
and number of Extended Battery
Modules (EBMs), the "Battery Low"
warning may occur before the
battery reaches 20% capacity.
The UPS is powering and
protecting the equipment
Equipment is powered but not
protected by the UPS.
5-6kVA EU_EN