Copy-Crafter - Craftsman 113.24907 Owner's Manual

MOUNTING COPY-CRAFTER BED TO LATHE
BENCH : •
I. Remove _he Too Rest Base and lock ng hardwarefrom
the Lathe (see your Lathe Owners Manual) and p ace
the Tailstock appr0ximateiy 24 inches from the
HeadstoCk: • •
NOTE: If" your Lathe has a Tool Rest Bracket and
i0cking harclware like the one shown in this illustration
be sure to unscrew the Threaded Slide and remove it
from the Tool Rest Bracket as shown before mountir_g
the Copy-Crafter bed,
REMOVE THIS THREADED SLIDE
FROM THE TOOL _EST BRACKET
BEFORE MOUNTING COPY-CRAFTER
/
2= Position the Copy-Crafter Bed on the Lathe Bench so
that the Lathe Bed is between the two Vertical
Channels of the Copy-Crafter and the Copy-Crafter
label faces the operator.
The front Vertical Channel should be 3-1/4 inches from
the Lathe Bed and 1/2 inch from the foot of the
Headstock as shown.
3. Check this distance at the other end making sure it is
also 3-t/4 inches. The Copy:Crafter Bed should now be
parallel to the Lath_ Bed.
)
4. Without moving the Copy-Crafter Bed, carefully mark
location of 8 bolt holes,
a. Trace the square portion of the Key Hole at the end
of each Vertical Channel,
b. Trace the 2 square holes in the center of each
Vertical Channels. You may have to move the
Taifstock to trace these hotes.
Remove the C0py-Crafter Bed and drill 3/8-inch holes
in: th_ Center of the marked squares.
6_, Att_h_heCbpY:C_after Bed to the Lathe Bench using
(8) eight Round Head Carriage Bolts, (2) two inches
I0ng and F|ange Nutsi'
SQUARE HOLE
KEYHOLE
6