Craftsman 113.24907 Owner's Manual page 5

assembly
ROUND HEAD BOLTS
AND FLANGE NUTS
BED ASSEMBLY
The Copy-C;rafter Bed is made up of (3) three Channels
held together by T{e Rods. All (3) three Channefs are the
same except one has the Copy-Crafter label. This is the
Front Channel, The other (2) two are Vertical Channels.
1. Assemble the Front Channel and (I) one of the Vertical
Channels as shown using (2) two Round Head Carriage
Bolts 3/4 inches long and (2) Flange Nuts.
FRONT CHANNEL
2.
Screw (2) two Plain Hexagon Nuts and (2) Flange Nuts
on each Tie Rod as shown. The Flange Nuts should be
equal distance from each end of the Tie Rods.
VERTfCAL CHANNEL
ii Ull n
'_ 7-3/4 INCHES
HEXAGON NUT
I FLANGE NUT EQUAL DISTANCE
3.
Hold the Flange Nut on the end of each Tie Rod with a
1/2 inch wrench or pliers and using another 1/2 inch
wrench, tighten the Plain Hexagon Nut firmly against
the Flange Nut as shown.
4. Lay the Channels on a flat surface and line up the ends
of the Channels using a combination square as shown.
5. Insert the Tie Rods into the second Key Hole from the
end of each Vertical Channel. The bend in the Tie Rods
should face downward.
6. Move the Tie Rods into the square portion of the Key
Notes.
7. With the Channels still in line, screw a Flange Nut on
the end of each Tie Rod as shown. Tighten the Flange
Nut.
\