Programming; To Erase All Codes; 3-Function Remotes - Craftsman 139.53962SRT1 Owner's Manual

PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷ remote controls.
To Add an Additional Hand.held Remote Control
USING THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-
held remote* that you wish to
operate your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
\1 /
1,
Press and hold the button on
the hand-held remote* that you
wish to operate your garage
door.
2,
While holding the remote
button, press and hold the
LIGHT button on the Premium
Control Console.
,
Continue holding both buttons
while you press the push bar on
the Premium Control Console
(all three buttons are held).
4,
Release buttons when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will
be heard.
\1 /
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted
remote, first erase all codes:
Press and hold the "learn" button
on motor unit until the learn
indicator light goes out
(approximately 6 seconds). All previous codes are
now erased. Reprogram each remote or keyless
entry you wish to use.
*3.Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it.
Additional buttons on any Security÷ 3-function
remote or compact
remote can be _ _
programmed to operate
other Security÷ garage
door openers.
35