Craftsman 139.53962SRT1 Owner's Manual page 26

INSTALLATION STEP 12
Connect Door Arm to Trolley
Follow instructions which apply to your door type as
illustrated below and on the following page.
SECTIONAL DOORS ONLY
• Make sure garage door is fully closed. Pull the
emergency release handle to disconnect the outer
trolley from the inner trolley. Slide the outer trolley
back (away from the pulley) for 8" minimum as
shown in Figures 1, 2 and 3.
• Figure 1:
- Fasten straight door arm section to outer trolley
with the 5/16"xl" clevis pin. Secure the
connection with a ring fastener.
- Fasten curved section to the door bracket in the
same way, using the 5/16"x1-1/4" clevis pin.
• Figure 2:
- Bring arm sections together. Find two pairs of
holes that line up and join sections. Select holes
as far apart as possible to increase door arm
rigidity.
• Figure 3, Hole alignment alternative:
- If holes in curved arm are above holes in straight
arm, disconnect straight arm. Cut about 6" from
the solid end. Reconnect to trolley with cut end
down as shown.
- Bring arm sections together.
- Find two pairs of holes that line up and join with
screws, lock washers and nuts.
• Pull the emergency release handle toward the
opener at a 45 ° angle so that the trolley release
arm is horizontal. Proceed to Adjustment Step 1,
page 28. Trolley will re-engage automatically when
opener is operated.
Pulley
i i
'#¢-_- 8" MIN.._:
Stop Bolt inner , Outer
/ Trolley _!!!_iii
Ring .
Ciev_s Pun
Fastener 5/16"xl"
Release
0 Door _ Relne_Se
: Bracket
1P._U rv Straight
Door Arm
Figure 1
Figure 2
MIN..
Screws
"_ 5/16"q 8x7/8"
Door Bracket
HARDWARE SHOWN ACTUAL SIZE
© ©0'
Nut 5/16"-18 Lock Washer 5/16" Ring Fastener
G ol
Clevis Pin Clevis Pin Hex Screw
5/16"x1" (Trolley) 5/16"xlq/4" (Door Bracket) 5/16"-18x7/8"
Figure 3
Pulley
/! 0.,. !
_-.- n' .---._!
Trolle_!y 1
Stop :;' k
Washers
Nuts 5/16"
5/16"
5S/_r6.q8x7/8 ,,
26