ProForm 831.15934 Owner's Manual page 6

.
.
.
Insert the lower end oF _ne Le[t Arm (15) into the refi'
side of the Moment Arm (74). Make sure that the
bracket on the end of the Left Arm is positioned as
shown in the inset drawing. If the bracket is not
positioned as shown, the Left Arm will not function
properly.
Align the hole in the end of the Le[t Arm (15) with
the holes in the Moment Arm (74_. Insert the 3/4" x
4" Axle (54) into the Moment Arm and the Left Arm.
Tap a 3/4" Plastic Cap (57) onto the Axle.
Attach the Right Arm (16) in the same manner.
Wrap the Weight Cable (52) under a 3 1/2" Pulley
(5). Attach the Pulley and a Cable Trap (67) to the
back of the Upright (9] with a 3/8" x 1 3/4" Bolt
(40) and 3/8" Nylock Nut (6). Make sure that the
Cable Trap is in the "7 o'clock" position.
Lay the Weight Cable (52) over a 3 1/2" Pulley (5}.
Attach a Cable Trap (67) and the Pulley to the [eft
side oF the Upright (9] with a 3/8" x 1 3/4" Bolt
(40) and 3/8" Nylock Nut (6). Make sure that the
Cable Trap is in the "12 o'cloc_ position.
Wrap the Weight Cobb (52) around a 2" Pulley (4).
Attach the Pulley to the Left ,_'m (15) with a 3/8" x
1 3/4" Bolt (40) and 3/8" Nylock Nut (6}.
Wrap the Weight Cable (52) around a 2 3/4"
Pulley (13). Attach the Pulley to the indico_ed bracket
on the Upright (9) with a 3/8" x 1 3/4" Bolt (40)
and 3/8" Nylock Nut (6).
7
9
15
/
/
/
/
Cibrrect position of Arms
/ again._t Moment Arm "
74
INCORRECT CORRECT
4O
67
5
67 5
S