DeLonghi ECAM23.46X Instructions For Use Manual page 23

FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
HOT WATER
Confirm?
The coffee beans have run out.
The pre-ground coffee funnel (A6) is clogged.
The infuser (A12) has not been replaced after
cleaning.
The tank (A10) is not correctly in place.
The inside of the appliance is very dirty.
The water softener filter (C4) is exhausted.
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
The hot water spout (C6) is not inserted or is
inserted incorrectly.
The milk container (D) is not inserted correctly. Insert the milk container (fig. 20) as far as it
The water circuit is empty.
Fill the beans container (A7) (fig. 12).
Empty the funnel with the help of the brush
(C5) as described in section "13.8 Cleaning the
pre-ground coffee funnel".
Insert the infuser as described in section ""13.9
Cleaning the infuser".
Insert the tank correctly and press as far as it
will go (page 3B).
Clean the inside of the appliance thoroughly,
as described in section "13. Cleaning". If the
message is still displayed after cleaning, con-
tact a service centre.
Replace the filter or remove it as described in
the "Water softener filter" section.
Turn the froth adjustment dial (D1) to the
CLEAN position.
Insert water spout as far as it will go.
will go.
Press
water spout (C6) until it flows out normally. If
the problem persists, make sure the water tank
(A10) is fully inserted.
22
(B9) to deliver water from the hot