Oil Line Connections - Riello F10 Installation Manual

ELECTRODE SETTING
IMPORTANT:
THESE DIMENSIONS MUST BE OBSERVED AND VERIFIED.
D6003
5/32" or 4 mm
5/32" to 13/64" or 4 to 5_ ....................
-I--
tt_
TURBULATOR SETTING
A) Loosen NUT (1), then turn SCREW
(2) until the INDEX MARKER (3) is
aligned with the correct index number
as per the Burner Set-up chart, on
page 12.
B) Retighten the RETAINING NUT (1).
NOTE: Zero and five are scale indica-
tors only. From left to right, the first line
is 5 and the last line 0.
5111111
OIL LINE CONNECTIONS
This burner is shipped with the oil pump set to operate on a single line system.
To operate on a two line system the by-pass plug must be installed.
Warning: Do not operate a single line system with the by-pass plug installed.
Operating a single line system with the by-pass plug installed will result in damage
to the pump shaft seal.
Note: Pump pressure must be set at time of burner start-up. A pressure gauge is
attached to the PRESSURE PORT (8) for pressure readings. Two PIPE
CONNECTORS (5) are supplied with the burner for connection to either a single or a
two-pipe system. Also supplied are two ADAPTORS (3), two female 1/4" NPT, to adapt
oil lines to burner pipe connectors. All pump port threads are British Parallel Thread
design. Direct connection of NPT threads to the pump will damage the pump body.
F10- 8