Table of Contents
Advertisement
PROBLEM
The washer is
overloaded.
The washer
has a suds
build-up.
The lid can't
lock or the lid
is open.
The washer
is out of
balance.
Your washer sounds a musical series of beeps every 5 seconds and... possible solutions.
Some lights are on but the pattern of lights is unfamiliar.
Turn your washer off at the wall.
1
Wait for 60 seconds and turn it back on.
2
Check the washer is level (refer to 'Installation Instructions' page 9).
3
Remove load and retry.
4
Put through a 'Deep Rinse' and 'Spin'.
5
If the fault reoccurs, repeat Step 1.
6
If the washer still will not work you will be required to call a Fisher & Paykel supported
and trained service technician to arrange service (refer to page 45).
38
BEFORE YOU CALL FOR SERVICE
DISPLAYED AS
WHAT TO DO
'High' water
The washer is overloaded and cannot agitate. Ensure
level light
the washer is stationary. Remove items until the
flashing.
remaining ones can move freely.
Select a higher water level.
First 'Rinse'
The washer has a suds build-up (too much detergent
progress or
may have been used for the amount of soil in the
'Spin' progress
load). Wait for suds to dissolve (about 20 min.) Rinse
light flashing.
clothes using a deep rinse.
'Lid Locked'
Make sure the lid is closed.
light flashing.
Press
If the symptom persists call you Fisher & Paykel dealer
or Fisher & Paykel trained and supported service
technician.
First 'Rinse' or
Wash load is out of balance. Ensure the washer is
'Spin' progress
stationary. Manually redistribute the load.
light flashing.
Check the washer is level (refer to 'Installation
instructions' page 9).
(refer to page 16).
Hide quick links:
Advertisement
Table of Contents
