Table of Contents
Advertisement
CHANGING PRE-SET OPTIONS
Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out of
balance load is detected, the washer will stop and re-try spinning up to three times. If it
still senses an unbalanced load there are two options the washer can take.
Automatic recovery option
Your washer will try to automatically correct the out of balance load. It will fill with
water and agitate to redistribute the load before trying to spin up again.
Washer stops option
Your washer will stop, give a short burst of beeps every five seconds, and the 'Rinse'
or 'Spin' light will flash. You must redistribute the load more evenly yourself (use this
option if you wish to conserve water).
WashSmart™
QuickSmart™
'Regular'
'Regular'
'Regular'
'Regular'
light on
light off
light on
light off
= automatic recovery
= washer stops
= automatic recovery
= washer stops
Adjusting the out of balance recovery routine
34
Hide quick links:
Advertisement
Table of Contents
