Table of Contents
Advertisement
Page 92
2. This command must be sent as an independent data stream
immediately following the <ESC>A Start code and immediately
preceding the <ESC>Z Stop code. No other commands can be
included in the data stream.
3. If more or less than nine commas are included in the command,
the entire command sequence will be ignored. The command
must contain exactly nine commas.
4. If two characters are specified for a parameter, it will be
interpreted as a hex value. For example:
Command Parameter
2B
+
If a combination of characters are outside the hexadecimal range,
the entire command sequence will be ignored.
5. The current protocol command codes may be verified by printing a
self test label (<ESC>CT).
PN 9001092 Rev. A
CX208/212 Programming Guide
Resulting Command Code
+
+
SATO CX208/212 Printers
Advertisement
Table of Contents
