Fisher & Paykel OR90 Series Installation Manual page 13

Fitting the lock pin (models with a storage/warming drawer)
The anti-tip bracket is accessible by removing the storage/warmer drawer, and is
positioned on the rear right side of the cooker.
A
To remove the storage/warming drawer
1
Open the storage/warming drawer completely.
2
Move down the lever of left guide A and up the lever of right guide B.
3
Remove the drawer holding the levers in the same position.
IMPORTANT
Do not remove storage/warming drawer while hot or during operation.
●
Be sure storage/warming drawer is empty before removing.
●
Always position your hand below the front panel to open/close the drawer.
●
bracket mounted
to rear wall
lock pin
6 Fit the lock pin through the bracket as shown
7 Insert the drawer guides onto the sliding runners on either side of the cooker interior.
Make sure they are correctly lined up on both sides of the drawer.
●
8 Gently close the drawer completely. The safety catches will automatically lock into place.
!3
INSTALLING THE ANTI-TIP BRACKET
B
Fitting the lock pin (models with a storage compartment)
The anti-tip bracket is accessible by opening the storage compartment door., and is
positioned on the rear right side of the cooker.
1 Open the storage compartment door.
bracket mounted
lock pin to rear wall
2 Fit the lock pin through the bracket as shown.
3 Close the storage compartment door.
13