Garmin EDGE 800 Owner's Manual page 28

ANT+ Sensors
5. Place the spoke in the groove of the
plastic piece, and tighten it slightly.
The spoke magnet can face away
from the GSC 10 if there is not
enough room between the sensor
arm and the spoke. The spoke
magnet must line up with the
indication line
arm.
6. Loosen the screw
arm.
7. Move the sensor arm to within
5 mm of the spoke magnet.
You can also tilt the GSC 10 closer
to either magnet for improved
alignment.
8. Press the Reset key
GSC 10.
The LED turns red, then green.

on the sensor
➑
on the sensor
➒
on the
➓
9. Pedal to test the sensor alignment.
The red LED blinks each time the
pedal magnet passes the sensor.
The green LED blinks each time
the spoke magnet passes the sensor
arm.
NOTE:
The LED blinks for
the first 60 passes after a reset.
Press Reset again if you require
additional passes.
10. When everything is aligned and
working correctly, tighten the cable
ties, the sensor arm, and the spoke
magnet.
When the GSC 10 is paired, a message
appears, and the
cadence icons appear solid on the
status page.
Edge 800 Owner's Manual
speed and