Installing The Gsc 10 - Garmin EDGE 800 Owner's Manual

ANT+ Sensors
5. Insert the new battery with the
positive side facing up.
NOTE: Be careful not to damage
or lose the O-ring gasket on the
cover.
6. Use a coin to twist the cover
clockwise so the arrow on the cover
points to CLOSE.


Installing the GSC 10

NOTE:
If you do not have a GSC 10,
you can skip this step.
Both magnets must be aligned with
their respective indication lines for the
Edge to receive data.
1. Place the GSC 10 on the rear chain
stay (on the side opposite the drive
train).
NOTE: Place the flat rubber pad
or the triangle-shaped rubber pad
between the GSC 10 and the chain
stay for stability.
Edge 800 Owner's Manual
➊