Installation; Positioning The Projector; Adjustable Feet - Sanyo PDG-DWL2500 Owner's Manual

Installation

For projector positioning, see the figures below. The projector should be set perpendicularly to the plane of the
screen.
Screen Size
(W x H) mm
16:10 aspect ratio
A
B
C
D
E
Projection angle can be adjusted within -1.0 to +1.0 degree
with the adjustable feet.
Rotate the adjustable feet and tilt the projector to the proper
height; to raise the projector, rotate the both feet clockwise.
To lower the projector or to retract the adjustable feet, rotate
the both feet counterclockwise.
To correct keystone distortion, press the KEYSTONE
button on the remote control or on the top control or select
Keystone from the menu (See pages 26, 40, 47).

Positioning the Projector

A
B
C
Screen
60"
1292 x 808
12.60" (32.0 cm) 16.14" (41.0 cm)
9.06" (23.0 cm) 12.60" (32.0 cm)
-2.60" (-6.6 cm) 0.95" (2.4 cm)
8.86" (22.5 cm) 10.43" (26.5 cm)
1.85" (4.7 cm) 3.43" (8.7 cm)

Adjustable Feet

4Note:
• This projector is not equipped with an optical
zoom. To adjust the screen size, change the
throw distance.
• The brightness in the room has a great
influence on picture quality. It is recommended
to limit ambient lighting in order to obtain the
best image.
• All measurements are approximate and may
vary from the actual sizes. Make sure to check
the position of images by projecting images
on the screen before installing the projector
and screen, since each projector shows slight
variations.
• Make sure to project images on a flat screen.
• Even slight warpage or irregularities of the
screen may have an effect on the quality of the
projected images.
80" 110"
1723 x 1077 2369 x 1481
21.46" (54.5 cm)
17.91" (45.5 cm)
6.26" (15.9 cm)
12.80" (32.5 cm)
5.79" (14.7 cm)
Adjustable Feet
15