Descaler; Preparing Replacement Product Bags - Cornelius HELIX Installation Manual

Descaler

Preparing Replacement Product Bags

© 2012-2014, Cornelius Inc. All Rights Reserved
The ice maker sanitation can be set to the following time intervals: Yearly, Bi-
Yearly, Quarter, and Monthly. It is recommended that the ice maker is scheduled
for sanitation once a month. Once the frequency is selected, the other options
allow the user to select which day of the week, hour, minute, and AM/PM for the
sanitation cycle to occur.
Press the check mark to go to the next menu. Another window is displayed
requesting the user to select the frequency of the Ice Maker Sanitation and Des-
caler process.
The descaler process is scheduled to be performed during normal ice maker san-
itation. The descaling frequency is set in a pop-up window that is displayed imme-
diately after the user sets the ice maker sanitation schedule.
The multiplier option allows the user to choose 1, 2, 3, etc. This controls how often
the descaler runs in relation to the ice maker sanitation process. For example, if
the ice maker sanitation is set to monthly, and the multiplier for descaler is set to
2x. Then the descaler process is preformed every two months.
! !
WARNING: WARNING:
Syrup bags must not be connected or prepared until all ingredient lines have
been sanitized and the unit has been pre-chilled to operating temperature (32-
40° F). Refer to the "System Sanitation" on page 18.
The Ingredient Status Screen is used to prepare the bags. The Ingredient Status
Screen shows the location for each syrup bag in the cabinet. The level indicators
show the amount of product in each bag. To prepare the system after replacing a
product bag, perform the procedure in Table 4.
- 21 -
Helix Installation Manual
Figure 15
Publication Number: 621058497INS