Right And Left Console Cover; Bottom Cover; Temperature Controller And Potentiometer (Gas Model); Hi Limit Thermostat (Gas Model) - Vulcan-Hart VGCTS16 Service Manual

ROUND TILTING BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
RIGHT AND LEFT
CONSOLE COVER
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove screw at the rear of the cover.
2. Lift up on cover while working it back and forth
to free it at the front.
3. Reverse procedure to install.

BOTTOM COVER

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Tilt braising pan forward until it comes to rest
on the stop bar.
2. Remove screw(s) holding the round cover.
3. Reverse procedure to install.
TEMPERATURE CONTROLLER
AND POTENTIOMETER
(GAS MODEL)
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
WARNING: SHUT OFF THE GAS SUPPLY
BEFORE SERVICING THE UNIT.
1. Remove right console cover as outlined under

"RIGHT AND LEFT CONSOLE COVER".

2. Pull out the right side access panel to expose
the compartment controls.
3. Loosen the two set screws from the
temperature dial and pull the dial off.
4. Remove the bezel ring and potentiometer
mounting screws.
5. Remove the nut securing the potentiometer to
the mounting bracket.
6. Disconnect the lead wires from the temperature
controller board.
7. Remove the mounting screws.
8. Reverse procedure to install a new temperature
controller and check for proper operation.
HI LIMIT THERMOSTAT
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
WARNING: SHUT OFF THE GAS SUPPLY
BEFORE SERVICING THE UNIT.
1. Remove the bottom cover as outlined under
"BOTTOM COVER".
2. Remove the screws securing the heat shield
box to the underside of the pan and lift off.
3. Disconnect the lead wires from the high limit.
Page 8 of 24
(Gas Model)