Bearings; Limit Switch (Gas Model) - Vulcan-Hart VGCTS16 Service Manual

ROUND TILTING BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
5. Unbolt the braising pan from the mounting
surface or stand.
6. Lay the braising pan on its back to expose the
four base plate mounting nuts and bolts.
7. Remove the nuts and carriage bolts on the right
side to separate the base plate from the right
side support member.
8. Gently strike the inner side of the support
member by hand or rubber mallet to dislodge
the pan assembly sleeve from the bearing.
Before the sleeve separates from the bearing,
grasp the pan for support.
9. Grasp the pan firmly and then pull it away from
the left side bearing.
NOTE: CHECK CONDITION OF BOTH BEARINGS
WHILE PAN IS OUT AND REPLACE IF
NECESSARY.
10. Replace with a new pan and reverse procedure
to install.
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove the pan assembly as outlined under
"PAN ASSEMBLY".
2. Remove the bearing to be replaced from the
support member.
NOTE: CHECK CONDITION OF BEARING ON
OPPOSITE SIDE AND REPLACE IF NECESSARY.
3. Replace with a new bearing and reverse
procedure to install.

LIMIT SWITCH (Gas Model)

WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1. Remove right console cover as outlined under
"RIGHT AND LEFT CONSOLE COVER".
2. Pull out the right side access panel to expose
the compartment controls.
3. Disconnect the lead wires from the switch.
4. Tilt braising pan forward until it comes to rest
on the stop bar.
5. Remove the screws securing the switch to the
bracket.
6. Reverse procedure to install and check for
proper operation.
Page 11 of 24

BEARINGS