Before Using, Register Second Handset To The Base Unit - Sanyo CLT-5812 Instruction Manual

UP016DH(CLT5812) ENG OM
GETTING

Before using, register second handset to the base unit

When the dual handsets are removed from the packaging, the
handset that is placed in the base unit first (to charge battery for 15-
20 hours), will automatically be registered to the base unit. (It does
not matter which handset you choose to place in the base unit first.)
You will also need to register the second handset by placing it in the
base cradle.
The second handset WILL NOT operate properly until the registration
has been completed. Once the handset is registered, it is ready for use.
Follow these simple steps to register:
1
First, install the battery packs in both handsets. Place either
handset in the base, then place the second handset in the
charging cradle. Charge both handsets for 15-20 hours.
2
After fully charging both handsets, remove the handset in the
charging cradle, and place it in the base. The CHARGE/IN USE LED
light on the base will begin to flash, indicating that the registration
is taking place between the second handset and the base.
3
Wait for at least 5 seconds before removing the handset from
the base.
Congratulations, the registration has been completed, and your dual
handset cordless phone is ready for use!
Notes:
• When you charge the handset, Caller ID
summary screen and the name of the handset,
HS1 HS2
appears. If
the handset No. 2.
• The charging cradle can be used to charge either handset.
3/7/05 5:21 PM
STARTED
appears, you are charging
Page 9
E9