Mounting The Base Unit On A Wall - Sanyo CLT-9902 Instruction Manual

All manuals and user guides at all-guides.com
CLT9902 #4 (SANYO) 8/11/00
Connections
M Connect the base unit
1

Mounting the base unit on a wall

M Standard wall plate mounting
This phone can be mounted on any standard
telephone wall plate.
1
4:14 PM Page 5
1
Snap the bottom bracket into the notches on the base.
2
Connect the AC adapter to the DC IN 9V jack and to a standard 120-V
AC wall outlet. Then raise the base antenna to a vertical position.
3
Connect the telephone line cord to the TEL LINE jack and to a telephone
outlet.
2
To AC outlet
To DC IN 9V
AC adapter
(supplied)
3
To telephone outlet
Telephone line cord
(supplied)
When connecting the power cord, make sure it does not create
a trip or fire/electrical hazard. Avoid places where it could
become chafed.
1
Snap the bottom bracket into the notches on
the base.
2
Plug the telephone line cord to the TEL LINE
jack and the AC adapter to the DC IN 9V jack.
3
Plug the telephone line cord into the telephone
outlet.
4
Fit the AC adapter cord into the molded channel.
Then wrap the cord around the strain relief
notch.
2 - 7
5
Plug the AC adapter into a standard 120-V AC
wall outlet.
6
Raise the antenna to a vertical position.
7
Align the mounting holes on the base with the
mounting posts on the wall plate. Push in and
down until the phone is firmly seated.
E4
To TEL LINE
Use only the AC adaptor that is supplied
with your phone.