When To Re-Register Handsets; Call Transfer Feature - Sanyo CLT-5812 Instruction Manual

UP016DH(CLT5812) ENG OM
GETTING

When to re-register handsets

1
You'll need to re-register the second handset (follow steps on
page E9) each time the digital security code is changed. Refer to
page E38 for details regarding the Digital Security Code.
2
When there is a power failure for more than one hour:
If power failure occurs (e.g. due to electrical storm or if the unit
is unplugged during a move), both handsets will need to be re-
registered. To re-register, follow the same registration process
on page E9.

Call transfer feature

Conveniently, your cordless phone allows you to transfer outside
calls from handset to handset, simply by pressing the DELETE/TRANS
key. Not to worry, conversations will not be interrupted; only one
handset at a time can talk with an outside caller.
The second handset cannot go off hook to listen to conversations or
make an outgoing call while the other handset is in use.
To transfer a call (to the second handset)
1
Press the DELETE/TRANS key during a call.
The call will automatically be placed on
hold and the transfer tone sounds.
2
When the other handset receives the call, the transfer tone
stops. To cancel the transfer, press DELETE/TRANS or TALK/FLASH
on the handset.
To receive a transfer call (from the second handset)
Pick up the handset (when Automatic Talk is
set to On), or pick up the handset and press
the TALK/FLASH key to answer the transferred
call. Additionally, you can answer the transferred call by pressing any
number key, the
to On).
Notes:
• If the second handset's battery becomes very low, the handset must be
recharged for 15-20 hours and re-registered to the base unit.
• If you transfer the call and it is not picked up after 5 minutes, the call will be disconnected.
E10
3/7/05 5:21 PM
STARTED
/TONE/ , or #/
key (when Automatic Talk is set
Page 10