Clean Drip Tray & Exterior Surfaces; Reinstall Cup Rest - Cornelius A.B.S. Unit Operator's Manual

Automated Beverage System
Closing/Sanitation Procedures
42
Clean Drip Tray & Exterior Surfaces
Clean drip tray and all exterior surfaces with
warm soapy solution and rinse with clean
potable water.
Pour warm (NOT HOT) water down the drip
tray drain to flush drain line.
Inspect drive seal after cleaning to check for
proper installation.

Reinstall Cup Rest

The cup rest must be installed with the oval
rails up and the "Cup Positioning Bracket"
must be at the rear of the drip tray.
The cup positioning bracket, located on the
cup rest, contains a spring that is positioned so
it touches the cup in the cup holder as the cup
moves past the spring. This moves the cup to
the rear (based on the direction of movement)
of the cup holder. This insures that all cups
will be in the same position regardless of its
size.
Reinstall Conveyor
Align the drive pin on the left side of the con-
veyor assembly so that the conveyor seats
properly. The conveyor drive pin must engage
the drive socket on the gear box. When install-
ing the conveyor, it may be necessary to move
the conveyor manually to allow the drive pin
to insert into the drive socket.
Tighten the thumb screws on the cover.
© 1999 The Coca-Cola Company, Cornelius and
McDonald's Corporation. All Rights Reserved.