Handling Alarms & Errors - Alarm & Warning Messages - Cornelius A.B.S. Unit Operator's Manual

Automated Beverage System
Handling Alarms & Errors — Alarm & Warning Messages
Alarm & Warning Messages
When an alarm occurs, press the Silence/Alarm button to silence the alarm. Read the display
to determine the problem so that the appropriate corrective action can be taken.
LEFT and RIGHT arrow are used to scroll the alarm list and the number of unresolved warn-
ings and alarms are displayed with direction cues to scroll.
Listed below are all of the Alarm and Warning messages that may appear on the display
screen.
Message
(X) CUP OUT AT STATION (Y)
CLEAR SYRUP SOLD OUT
LOW ICE – REFILL SOON
CLEAR CUP JAM
NO CUP EXTRACTED
TURRET STALLED
CONVEYOR STALLED
AIR OR CO LOW OR OUT
2
52
Explanation
The cup tube for size (X) is empty at
station (Y).
The clear syrup (Sprite) is sold out
(empty B.I.B.).
Sensor must be installed and con-
nected to the A.B.S. system for this
warning to occur.
Ice level in the ice bin is too low.
Cup(s) jammed in the conveyor at
the cup extraction position and the
conveyor and turret are unable to
operate.
The gripper did not or could not
extract a cup from the cup tube.
Cup(s) jammed in the conveyor at
the cup extraction position and the
conveyor and turret are unable to
operate.
Cup(s) jammed in the conveyor at
the cup extraction position and the
conveyor and turret are unable to
operate
CO supply is low or empty or air
2
compressor not operating.
Corrective Action
Refill the empty cup tube with
the correct cup size and then
press ENTER to continue dis-
pensing.
Connect a new syrup supply and
the A.B.S. unit will continue.
If the ENTER button is pressed
before the syrup supply is
replenished, automatic opera-
tion will resume but only the cup
and ice will be dispensed for this
flavor.
Refill the ice bin with ice. Press
ENTER.
Remove all cups from the con-
veyor cup holders at the Extract
Position before pressing the
ENTER button. Another cup will
be extracted and dispensing will
continue.
Check cup supply at the extract
station and make sure the cups
are not stuck. Make sure the
gripper pads are not damaged.
Remove all cups from the con-
veyor cup holders at the Extract
Position before pressing the
ENTER button. Another cup will
be extracted and dispensing will
continue.
Remove all cups from the con-
veyor cup holders at the Extract
Position before pressing the
ENTER button. Another cup will
be extracted and dispensing will
continue.
Change CO cylinder pr have
2
bulk tank refilled. Check cause
not operating and repair.
© 1999 The Coca-Cola Company, Cornelius and
McDonald's Corporation. All Rights Reserved.