Aligning The Machine To The Driven Machine And Attaching It To It (Im V1, Im V10) - Siemens SIMOTICS FD 1MH1 Operating Instructions & Installation Instructions

Low-voltage motor

Table of Contents

Aligning the machine to the driven machine and attaching it to it (IM V1, IM V10)

The standard flange is provided with a centering. The choice of fit for the mating flange on the

driven machine is the system manufacturer's or the plant operator's responsibility.

Note

If the machine is not fitted with a standard flange, align the machine to suit the driven machine.

Procedure

The machine axis must be vertical when it is lifted and the flange must be parallel to the mating

flange, so as to avoid seizing and stressing. Otherwise damage to the centering will result.

1. Grease the centering flange with assembly paste to make the process easier.

2. Screw in two studs into tapped holes on opposite sides of the driven machine flange. The

3. Lower the machine slowly toward the driven machine and into the centering, so that the

4. If necessary, rotate the machine into the right position so that the clearance holes in the

5. Lower the machine completely onto the mating flange so that it is fully in contact; then

6. Fix the machine using the flange fixing bolts.

See also

Tightening torques for screw and bolt connections (Page 179)

SIMOTICS FD 1MH1

Operating Instructions 08/2017

WARNING

Mechanical tensions

The machine may be damaged by additional mechanical tensions in the housing caused

by incorrect mounting of the support base. The machine or machine parts may loosen

during operation.

This can result in death, serious injury or material damage.

● Mount the support base so that no additional mechanical tensions can occur in the

housing.

studs act as positioning aids.

flanges do not quite touch. Lowering too quickly risks damaging the centering.

flange are central to the tapped holes.

remove the studs.

Assembly

5.3 Installing the machine

Table of Contents

Simotics fd 1mq1 Simotics fd 1ll1