Table of Contents
Advertisement
9.2
Corrective Maintenance
Observe the following when carrying out any work on the machine:
● Comply with the general safety instructions
● Comply with the applicable national and sector-specific regulations at the place of
● When using the machine within the European Union, comply with the specifications laid
See also
Safety information (Page 15)
Explosion hazard when carrying out repair work
Repairs are only permissible within the scope of the work described in these operating
instructions. Otherwise an explosion can occur in an explosive atmosphere. This can result
in death, serious injury or material damage.
For repairs to go beyond this scope, please contact the Service Center.
See also
Service and Support (Page 177)
Comply with the IEC / EN 60079‑17 standard during all service and maintenance work on the
machine.
Note
If the motor has to be transported, please observe the information and instructions in the
"Transport" (Page 45) section.
9.2.1
Prepare servicing work
● The drawings and parts lists do not contain any detailed information about the type and
● Document the type, dimensions and arrangement of the parts so that you will be able to
● Use suitable tools to disassemble the machine.
SIMOTICS FD 1MH1
Operating Instructions 08/2017
installation
down in EN 50110‑1 regarding safe operation of electrical equipment.
WARNING
dimensions of fixing elements and components. For this reason, you should establish this
information when dismantling them and make a note of it for the purpose of reassembly.
reassemble the machine to its original state.
Maintenance
9.2 Corrective Maintenance
145
Advertisement
Table of Contents
