Putting The Machine Down - Siemens SIMOTICS FD 1MH1 Operating Instructions & Installation Instructions

Center of gravity not centered
If the center of gravity of a load is not located centrally between the attachment points, the
machine can tip over or slip out of the lifting equipment and fall when it is being transported
or lifted. This can result in death, serious injury or material damage.
● Comply with the handling instructions on the machine when transporting it.
● Be aware of the possibility of different loads on the sling ropes or lifting straps and the
● Always take account of the center of gravity when transporting or lifting the machine. If
Note
Place the machine in a secure and raised position
In order to obtain easy and safe access to the underside of the machine, place it in a secure
and raised position.
Standing under suspended loads
If the lifting gear or load handling attachments were to fail, the machine could fall. This can
result in death, serious injury or material damage.
● Never remain under or in the immediate vicinity of the machine when it is raised.
5.2.8

Putting the machine down

Requirements
The following preconditions must be satisfied before setting down the machine at the
installation location:
● The mating faces must be clean.
● The anti-corrosion protection paint has been removed from the mating faces, such as the
●
Setting down the machine
● Set down the machine slowly and carefully at the installation location to avoid any impact.
SIMOTICS FD 1MH1
Operating Instructions 08/2017
WARNING
carrying capacity of the lifting equipment.
the center of gravity is not located centrally between the attachment points, then position
the hoisting hook above the center of gravity.
DANGER
machine mounting feet, flange, ...
There is no condensation present within the machine.
5.2 Lift the machine to where it will be installed, and position it
Assembly
69