Vulcan-Hart SG4D Service Manual page 7

SG4 & SG6 Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
2. Reverse the procedure to install.
Bottom Front Cover
1. The bottom front cover is secured with six
screws, two on each side of cover and two on the
top. Remove these screws then remove the
cover from the oven.
Fig. 3
2. Reverse the procedure to install.
Control Panel
1. Remove three screws on the right side which
secure the control panel. Pull the panel away
from the oven.
Fig. 4
2. Disconnect the temperature probe leads from the
solid state temperature controller.
3. Unplug the wire harness connector to the control
panel components.
4. Reverse the procedure to install.
Right Side Panel
1. Remove the screws that secure the right side of
the control panel.
2. Remove the remaining screws securing the right
side panel.
3. Pull the right-side panel out at the bottom then
down to remove.
4. Reverse the procedure to install.
Page 7 of 56
Fig. 5
F35626 Rev. B (1118)