SG4 & SG6 Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove racks and right-side hand rack guide.
2.
Pull lamp cover off.
3.
Grasp lamp using a clean cloth and remove from
lamp assembly.
Fig. 45
4.
Reverse procedure to install new bulb.
NOTE: Verify gasket (1, Fig. 46) is flat on lamp cover
and not damaged.
F35626 Rev. B (1118)
Lamp Assembly Replacement
1.
Remove racks.
2.
Remove BULB if reusing.
3.
Lift right side rack guide off oven cavity.
4.
Pull lamp cover off from the top or bottom.
5.
Insert narrow blade screwdriver into tab and
bend out to release. Repeat with second tab.
Page 22 of 56
Fig. 46
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.