Vulcan-Hart SG4D Service Manual page 25

SG4 & SG6 Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Fig. 53
4. Reverse the procedure to install the replacement
fan and check for proper operation.
Fan Installation Tips
• The fan must be installed so air is pulled from the
rear of the oven and blown into the control area.
The arrow on the fan body indicates airflow
direction and should be pointing toward the
controls.
• Ensure the fan is seated squarely against the air
tube and the oven bottom.
• The air deflector should be angled upward at
approximately 30 degrees to properly direct the
airflow.
Page 25 of 56 F35626 Rev. B (1118)