Basic Operation; Turning The Power On/Off; Operating The Menu - Roland XS-42H Reference Manual

Basic Operation

Turning the Power On/Off

* Before turning the unit on/off, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/off. However, this is normal
and does not indicate a malfunction.
Turning the power on
1
Make sure that all devices are powered-off.
2
To turn on the power, slide this unit's [POWER] switch to
the ON position.
3
Turn on the power in the order of source devices0
output devices.
Turning the power off
1
Turn off the power in the order of output devices0
source devices.
2
To turn off the power, slide this unit's [POWER] switch to
the OFF position.
About the Auto Off function
The power to the unit turns off automatically when all of the
following states persist for 240 minutes (Auto Off function).
5 No operation performed on the unit
5 No audio or video input
5 No equipment is connected to the OUTPUT HDMI connectors
If you do not want the power to be turned off automatically,
disengage the Auto Off function. Long-press the [MENU] button
0"System"0set "Auto Power Off" to "Disabled. "
NOTE
5 Unsaved data is lost when the power turns off. Before turning
the power off, save the data that you want to keep.
5 To restore power, turn the power on again.
6

Operating the Menu

Here's how to access the menu, and make video/audio settings and
settings for this unit.
5 The menu is shown only on the monitor that's connected to the
OUTPUT HDMI 2 connector.
1
Long-press the [MENU] button to display the menu.
The [MENU] button is lit red, and the menu categories are displayed.
2
Press the CURSOR [ ? ] [ = ] buttons to select a category,
then press the [ENTER] button to confirm the selection.
The menu items of the selected category are displayed.
3
Press the CURSOR [ ? ] [ = ] buttons to select a menu item.
5 If the value area indicates "Enter, " you can press the [ENTER] button
to proceed to a lower level.
Alternatively, pressing the [ENTER] button executes an operation.
5 Pressing the [MENU] button moves you back one level higher.
4
Press the VALUE [–] [+] buttons to change the value of
the setting.
5 By holding down the [ENTER] button and long-pressing the VALUE [–]
or [+] button you can change the value of the setting more greatly.
5 If you press the VALUE [–] and [+] buttons simultaneously, the
selected menu item returns to its default setting.
5
Press the [MENU] button several times to close the menu.
Saving your settings
With the factory settings, changes you make to menu settings are
automatically saved to the unit when you close the menu.
Common settings (one setting for the entire unit)
Unit
5 System menu
5 Output menu "Color Space, " "Signal Type"
5 Output menu
Scene 1
* Except for "Color Space" and "Signal Type"
Scene 2
5 Input menu
Scene 3
5 Composition menu (VP-42H)
5 Audio menu
5 Cross-point (XS-42H)
Scene 10
5 You can disable automatic saving of the settings. Long-press
the [MENU] button 0 "System" 0 set "Auto Setting Store" to
"Disabled. " If automatic storage is disabled, you should manually
store the current settings as necessary (p. 12).
5 For more about scenes, refer to "Recalling Video/Audio Settings
(Scenes)" (p. 9).
Long-press