Setup And Preparations; Rack-Mounting; Free-Standing Use - Roland XS-42H Reference Manual

Setup and Preparations

Rack-Mounting

Attaching the rack-mount angles
By attaching the included rack-mount angles to this unit, you can
mount it in a rack.
1
Remove the screws from the side panels.
2
Using the screws that you removed, attach the rack-
mount angles as shown in the illustration.
Important notes on rack mounting
5 Install in a well-ventilated location.
5 Do not block the cooling vents located on the unit's top
panel and side panels.
5 Avoid mounting the unit in a sealed-type rack. Warm air within the
rack cannot escape and is sucked into the unit, making efficient
cooling impossible.
5 If the back of the rack cannot be opened, install an exhaust port
or ventilation fan at the top back surface of the rack, where warm
air collects.
5 When using the unit while mounted in a movable case (portable
rack), remove the front and rear rack covers so that the front and
back of the unit are not obstructed.
5 Take care not to pinch your fingers etc. while mounting the unit
in a rack.

Free-Standing Use

Attaching the rubber feet
If you will be placing this unit on a desk or shelf for use, attach the
included rubber feet (4 pcs.). This prevents the unit from slipping or
from scratching the surface on which it is placed.
1
Remove the rubber feet from the sheet.
2
Peel the double-sided tape off the rubber feet, and affix
the feet so that they cover the four guide holes on the
bottom of the unit.
5