Dpu Operation; File; Setting; Service - Furuno WR-2100 Installation Manual

8. DPU operation

8.1. File

1) Operation mode: (Press [Ctrl] + [Alt] and click
[File] simultaneously to indicate the menu)
Do this operation mode after changed some
parameters to operate the radar.
- Observation:
Select the entered values at "Setting" menu
with regular mode.
- Verify operation during installation:
Change some parameters automatically to
verify operation during installation.
All parameters will set back to previous

setting

of
installation] if go back to "Observation"
mode.
2) File Play: To play a regular echo recorded file (scn,
scnd) with RainPlay software (Refer 8.7.).
Refer "2) Acquisition" on 8.3.1. for setting.
3) Snapshot: To indicate captured radar screen (jpg).
4) SPU Shutdown: (Click "File" + [Ctrl] + [Alt] at same
time to Indicate the menu)
*Invalid command.
5) Exit: To exit the software of RainMap.
8.2. Setting

8.2.1. Service

Press [Ctrl] + [Alt] and click [Setting] simultaneously to indicate service menu.
Service menu has two types:
1. Maintenance setting: Regular menu for maintenance service engineer.
2. Factory setting: Adjust the setting of installed station use only for installation engineer.
Notice: Follow the management list Setup all values.
1) Network
SPU
Select and setup the SPU channel.
Manual / 1ch (for WR-50) / 2ch (for WR-2100)
Command transfer IP
Setup the IP address of command transfer.
 Constant value: 192.168.1.100
Command transfer port
Setup the port number of command transfer.
 Constant value: 51000
Data transfer IP
Setup the IP address of data transfer.
 Constant value: 192.168.1.100
Data transfer port
Setup the port number of data transfer.
 Constant value: 52000
[Verify operation during
FTP server address
Setup the IP address of FTP server.
 Constant value: 192.168.1.100
FTP server port
Setup the port number of FTP server.
 Constant value: 50000
31
SSE-14-0023_17