Prime/Flush - Graco e-Xtreme Operation, Repair, And Parts

Table of Contents

Prime/Flush

To avoid fire and explosion, always ground

equipment and waste container. To avoid static

sparking and injury from splashing, always flush at

the lowest possible pressure.

1. Perform

Pressure Relief Procedure, page

2. Remove tip and tip guard from gun.

3. Place material supply suction hose into

compatible fluid (if priming) or solvent (if flushing).

3A3164D

4. Close drain valve.

5. Turn power switch (E) ON.

12.

6. Prime or flush hose and gun:

a. Disengage gun trigger lock.

b. Trigger gun into grounded pail. Pull out

pressure adjustment knob (H) and turn

clockwise slowly to increase pressure, until

a steady stream flows from gun. Push knob

in to lock. If flushing

solvent flows from the gun.

c. Engage trigger lock.

flushing, trigger gun until clean

flushing

Setup

Table of Contents